Table of Contents
Advertisement
Figure 2 - Typical Installation Illustration
3
SET UP
(Refer to Figure 1 & 2)
1. Remove the plug on oil port, connect 3/8" NPTF
hydraulic connection to oil port, i.e. coupler, hydraulic
hose, fitting etc. Ensure the oil ports and thread
connections are clean before connecting to the
hydraulic system.
NOTICE
Always secure threaded connections with
non-hardening pipe thread compound. Take care not to
introduce compound into port orifices. Tighten securely
to prevent accidental removal of components while in
use.
2. Connect the hydraulic connection to hydraulic
pump.
3. Install a pressure gauge to monitor the system
pressure.
DO NOT exceed rated pressure of 10,000 psi.
Bead Breaker
Advertisement
Table of Contents
