Table of Contents
Advertisement
2
Connecting your TV
TV front touchpad and side panel controls and connections
Front of TV
Remote sensor
1
Front touchpad*
EXIT
3
TV/VIDEO
2
TV/VIDEO
EXIT
CHANNEL
Channel zy
*Gently touch the printed keys on the touchpad.
1
Remote sensor
(behind the screen)
control toward this area of the TV screen. See "Remote
control effective range" on page 26.
2
— Repeatedly press to change the source you are
TV/VIDEO
viewing (ANT 1, ANT 2, VIDEO 1, VIDEO 2, VIDEO 3,
HDMI 1, HDMI 2, ColorStream HD1, ColorStream HD2).
3
— Press to close an on-screen menu instantly.
EXIT
4
zyx • — When a menu is on-screen, these
ARROWS
buttons function as down/up/left/right menu navigation
buttons.
5
— Press to access the menu system (see page 34).
MENU
When a menu is on-screen or the TV Guide On Screen
program guide is open, this button functions as the ENTER
button.
6
— Press to turn the TV on and off.
POWER
7
yz — When no menu is on-screen, these
CHANNEL
buttons change the channel (programmed channels only; see
page 41). When a menu is on-screen, these buttons function
as up/down menu navigation buttons.
8
x • — When no menu is on-screen, these
VOLUME
buttons adjust the volume level. When a menu is on-screen,
these buttons function as left/right menu navigation
buttons.
HMX94(E)009-11(2A-Cnct)
9
TV/VIDEO
EXIT
CHANNEL
VOLUME
MENU
POWER
zyx •
MENU
4
5
VOLUME
MENU
Volume x •
Green/Red LEDs
7
8
— Point the remote
Copyright © 2004 TOSHIBA CORPORATION. All rights reserved.
Reset button
0
POWER
Right side of TV
6
POWER
9
9
Green and Red LEDs
blinking), it indicates that the TV power cord is plugged in
and the power is OFF. This is called standby mode.
Note: When you first plug in the power cord, the green LED
will blink 3 times. After approximately 30 seconds, the green
LED will light continuously, at which point you can press
POWER to turn ON the TV.
When red lights solid (not blinking), it indicates that the
TV power cord is plugged in and the POWER is ON.
See "LED indications" on page 94 for additional
information.
0
— If the TV stops responding to the controls on
RESET
the remote control or TV front panel and you cannot turn
the TV off or on, press this button to reset the TV.
Note: The RESET button is recessed, so you will need to use
the end of a paper clip or similar object to press the button.
!¡
— The side panel A/V connections are referred to
VIDEO-3
as "VIDEO 3" and include standard A/V connections plus
optional S-video. (The VIDEO 1 and VIDEO 2 A/V
connections are on the TV's back panel; see page 10.)
!™
Memory card slots
the memory card slots to view JPEG files (such as photos)
as a "slide show" on your TV or listen to MP3 audio files
(see page 82).
9/28/04, 10:21 AM
Side panel
VIDEO-3 IN
Memory card
!¡
slots
!™
— When green lights solid (not
— Insert a memory card into one of
9
Advertisement
Table of Contents
