Table of Contents
Advertisement
FITTING THE PROPELLER BLADES
Fit the 3 propeller blades to the driven pulley in the order outlined below
1. Insert 2 of the 6 (M8 x 60mm) bolts into the prop disc and locate a single blade in
position. Ensure that each bolt has both a split spring washer then normal spreader
washer located on its shank before locating in the prop disc.
2. Locate a single blade in position on these two bolts and lightly screw the bolts into
position on the driven pulley.
3. Follow the same procedure for each blade but do not tighten the bolts until all three
blades are in position.
4. Finally tighten each bolt with equal torque hand tight only (be careful not to over
tighten and crush the carbon fibre propeller hubs)
Note – When installing the propeller, the propeller blade bolts should not be over-
tightened or the base of the propellers could be damaged, distorted and weakened.
Driven
Pulley
When installing the propeller blades make sure to match the balancing dots on each blade
with the corresponding dots on the adjacent blade. The dots can be located on at the bas
of each blade.
WARNING!!! Use of the powered paraglider is at your own risk.
Propeller Blade
Prop Disc
16
M8 x 60
Screws
Advertisement
Table of Contents
