Advertisement
BARIONE T
50
Quick Install Guide Version 1.2
Low Cost IP Automation
Controller with Modbus/TCP
and SNMP Support
Package contents
a Barionet 50
b This quick install guide
Mounting, Wiring and Setup
Slide the device upwards onto the DIN rail. Push it up and towards the rail
until it snaps onto the upper rail edge.
For wiring information please refer to the second page.
Before powering the device please read the user manual available on
www.barix.com.
Support
For support please contact your local dealer or visit www.barix.com.
© 2010 Barix AG , all rights reserved. All information is subject to change
without notice. All mentioned trademarks belong to their respective owners
and are used for reference only. Quick Install GuideV1.2 March 2010
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for BARIX BARIONET 50
Summary of Contents for BARIX BARIONET 50
- Page 1 Support For support please contact your local dealer or visit www.barix.com. © 2010 Barix AG , all rights reserved. All information is subject to change without notice. All mentioned trademarks belong to their respective owners and are used for reference only. Quick Install GuideV1.2 March 2010...
- Page 2 Barix devices can be daisy- chained using the extension bus BARI ONET connector J10. An extension cable for this purpose is supplied with the Barix IO12 and the Barix R6. The gap between devices is then STATUS RS-232 RS-485 REL1 REL2...
Need help?
Do you have a question about the BARIONET 50 and is the answer not in the manual?
Questions and answers