Toshiba G3 TOSVERT-130 Instruction Manual page 31

Example Table Excerpt:
Register Function / Title
26 MAXIMUM OUTPUT
FREQUENCY
BASE FREQUENCY #1
27
BASE FREQUENCY
28
VOLTAGE SELECT
MAXIMUM OUTPUT
29
VOLTAGE #1
REVERSE OPERATION
2A
DISABLE SELECT
Other Programming Register Notes:
= All register numbers indicated are in hexadecimal notation (for example, 29 hex =
41 decimal). Occasionally, hexadecimal notation in this document may also take
the form of a number beginning with "0x".
= Throughout this document, the abbreviations "LL", "UL", and "Fmax" will stand for
LOWER LIMIT FREQUENCY, UPPER LIMIT FREQUENCY, and MAXIMUM
OUTPUT FREQUENCY, respectively.
= Reading from or writing to registers marked as "Reserved" will generate an
"invalid register" error (error code 0x0003)
= Certain parameter registers cannot be written to while the inverter is running.
These registers will be indicated by the character ( ). If an attempt is made to
write to these registers while the inverter is running, a "cannot execute" error
(error code 0x0001) will be generated.
= The parameter register data for all read/write registers with Bank information
listed as 0/1 will be retrieved from bank 0 (RAM) during reads and will be written
to both banks 0 and 1 (RAM and EEPROM) during writes.
= All parameters in GROUP:COMMUNICATION SETTING PARAMETERS (section
11.2.10) are retrieved by the drive from non-volatile memory upon inverter
initialization only. When any of these registers are modified, therefore, the drive
must be reset for the changed values to take effect.
= If the COMMAND MODE SELECTION or FREQUENCY MODE SELECTION
parameters are changed while the drive is running, the change will not take effect
until the next time the drive is stopped.
Bank Mask
0 / 1 FFFF
( )
0 / 1 FFFF
0 / 1 0030
( )
0 / 1 FFFF
0 / 1 0020
30
Adjustment Range
0BB8 9C40 (30.00 400.00)
09C4 9C40 (25.00 400.00)
0000: Input voltage level
0020: Automatic setting
0030: Stationary setting
0000 0258 (0 600)
0000: Reverse allowed
0020: Reverse not allowed
Multiplier
0.01
0.01
(0)
(1)
(2)
1
(0)
(1)