2-3 Other Setup
2-3-4 Transport Belt Height
1.
Adjust the transport belt height using
belt plate height adjust screw. The standard
transport belt height is 1 mm (0.04") higher
than the press table surface.
NOTE
- When booklets do not reach to stopper, raise
support plate.
2-4 Binding Start
WARNING
- Do not separate FC-20A from SPF-
20A. Operate FC-20A and SPF-20A as
one complete system.
1.
Turn on SPF-20A main power and start
the operation.
- Booklets are trimmed only when stitching
& folding or folding mode is selected.
- Booklets pass through FC-20A when side/
corner stitching mode is selected.
Press Table
Belt Plate Height
Adjust Screw
13
2. Setup and Operation
Transport Belt
Support Plate