ABB REL 356 Instruction Booklet page 40

Table 2-4. Target (Fault Data) Information Continued
Target Description
DKM Fault distance in kilometers
PFLC Pre-fault load current
PFLV Pre-fault voltage
LP Pre-fault load angle
VAG VAG fault voltage magnitude
VAG fault voltage angle
VBG VBG fault voltage magnitude
VBG fault voltage angle
VCG VCG fault voltage magnitude
VCG fault voltage angle
3V0 3V0 fault voltage magnitude
3V0 fault voltage angle
IA IA fault voltage magnitude
IA fault voltage angle
IB IB fault voltage magnitude
IB fault voltage angle
IC IC fault voltage magnitude
IC fault voltage angle
3I0 3I0 fault voltage magnitude
3I0 fault voltage angle
DATE Date of fault (month.day)
YEAR Year of fault
TIME Time of fault (hours.minutes)
SEC Time of fault (seconds)
MSEC Time of fault (milliseconds)
LDT LDT used at the time of trip
XMTR Channel transmit level
*RCVR Channel receive level
*SNR Channel signal-to-noise ratio
**FEPH Channel error
Notes: The "YES/NO" targets are displayed only if they are "YES". The
impedance is dependent upon the CTYP setting. The internal
impedance values are for a 5A ct. The impedance value is multiplied
by 5 if a 1 A ct is used (CTYP = 1). The angles are not displayed if the
magnitude of the value or the reference is less than 0.5 a or 0.7 rms.
* 9600 bps Audio Tone Channel
** 56/64 kbps Digital Communication
Installation, Operation and Maintenance
ABB REL 356 Current Differential Protection
Format Units
XXX.X km
XXX.X amps
XXX.X volts
XXX.X deg
XXX.X volts
XXX.X deg
XXX.X volts
XXX.X deg
XXX.X volts
XXX.X deg
XXX.X volts
XXX.X deg
XXX.X amps
XXX.X deg
XXX.X volts
XXX.X deg
XXX.X amps
XXX.X deg
XXX.X volts
XXX.X deg
MM.DD
YYYY
HH.MM
XXXX sec
XXXX msec
XXX.X msec
XXXX dBm
XXXX dBm
XXXX dB
XXXX/FAIL
2-17