Advertisement
5. Remove the driver's dashboard lower cover
(two self-tapping screws, four retaining clips
and one connector).
GLASS HATCH
OPENER CONNECTOR
DRIVER'S DASHBOARD
LOWER COVER
Pull
CORRECT
6. Remove the lower console cover.
AT Model:
Remove the two self-tapping screws
attaching the right side of the center console.
CENTER
CONSOLE
SELF-
TAPPING
SCREWS
(SHORT)
CLIP
LOWER CONSOLE
COVER
Remove the two clips attaching the lower
console cover, then remove the cover by
pulling it toward you.
Remove the two self-tapping screws from
the bottom of the center console, open the
console pocket, and remove the four
self-tapping screws behind the pocket.
2 of 5
RETAINING
CLIPS
SELF-
TAPPING
SCREWS
INCORRECT
SELF-TAPPING
SCREWS
(SHORT)
SELF-
TAPPING
SCREWS
(LONG)
CLIP
RETAINING
CLIPS
MT Model:
Remove the change lever knob by sliding the
boot down while pressing down on the two
retaining tabs at the bottom of the knob, then
by turning it counterclockwise.
LOWER
CONSOLE COVER
SELF-TAPPING SCREW
Remove the four self-tapping screws and
two clips fastening the lower center console
cover and remove the console cover.
Remove the four self-tapping screws
securing the console pocket and remove the
pocket.
CONSOLE
POCKET
Remove the two clips that fasten the lower
center console lining and remove the lining
by lifting it upward.
AII 20248 (9812)
CLIP
SELF-TAPPING
SCREW
LOWER CENTER
CONSOLE LINING
CLIP
1998 American Honda Motor Co., Inc. – All Rights Reserved
CHANGE
LEVER
KNOB
RETAINING
TABS
CLIP
Advertisement
