Ugo ZEPHIR 2.0 User Manual page 5

Standard operation steps:
Place the drone on te at surface
For raising and falling the please use the left stick of the remote control. After moving it up to
the drone it will start to rise, aftermoving down, the drone will start to fall.
Moving the left control stick to the left, the drone will rotate around its axis to the left, move the
left control stick to the right, the drone will rotate around its own axis to the right.
For the forward and reverse ights the right control stick is responsible. When you move the lever
forward, the drone will start to move forward, after moving the lever down, the drone will move
backwards.
Moving the right control stick to the left, the drone will move to the left, move the left joystick to
the right, the drone will move to the right.
Flips and rolls:
After you have the basics of ying, you're ready to learn ip and roll your
drone. To perform a ip or roll, make sure the drone is at least 3 meters o the
ground. Press the button Flip, then quickly push the rudder in either direction
to make the drone ip or roll. Once the manoeuvre is completed, steady the
drone.
Gyroscope Reset:
Before rst ying, pull the Throttle and Rudder down to 45 degree (Bottom
Right corner as picture) for 2-3 seconds, you will hear beep 'Di-Di' , then let
go of the Throttle and Rudder. And gyroscope reset complete.
EN PL CZ SK