Removing Memory Module - Toshiba Satellite 2450 User Manual

12. Insert the tabs of the keyboard into the slits of the computer case and seat the
keyboard at the original position. Fix it with three screws removed in 6.
CAUTIONS: 1. Be sure to use all screws that were removed in 6 and
13. Seat the keyboard brace in the original position.
14. Install the battery pack as described in Chapter 6,
Modes.
15. Turn the power on and make sure the added memory is recognized. Open
System Properties in the Control Panel and click the General tab.

Removing memory module

To remove the memory module, make sure the computer is in boot mode then:
1. Be sure the power is off and all cables are disconnected from the computer.
2. Turn the computer upside down and remove the battery.
3. Follow the instructions 4 through 9 in "Installing memory module" to appear
memory module.
4. Push the latches to the outside to release the module. A spring will force one
end of the module up.
5. Pinch the module by the sides and pull it out.
CAUTIONS: 1. If you use the computer for a long time, the memory
do not leave foreign matters such as adhesive tape
used in 9 or screws removed and dropped in the
computer.
2. When seating the keyboard at the original position, be
sure to return the flexible printed circuit board under
the metal sheet if the flexible printed circuit board was
dragged out while removing the keyboard.
modules and the circuits locating close to the memory
modules will become hot. In this case, let them cool to
room temperature before you replace them. Or you will
get burnt if you touch any of them.
2. Do not touch the connectors on the memory module or
on the computer. Debris on the connectors may cause
memory access problems.
Memory expansion
Power and Power-up
8-11