Powering On/Off - GoPro SMART REMOTE User Manual

CHARGING
1. Slide and hold the latch lever in the
direction of the arrow (A), then pull
the key out of the remote (B).
2. Insert the charging cable into the
remote until it clicks into place.
POWERING ON + OFF
POWERING ON
Press the Power/Mode button .
3. Connect the other end of the
cable to a computer or other
USB power source.
Note: Be sure that the computer is
connected to a power source. If the
remote status screen does not indicate
that the remote is charging, use a
different USB port.
POWERING OFF
Press and hold the Power/Mode
button for two seconds.
2 sec
PAIRING THE REMOTE AND YOUR GOPRO
You can pair the Smart Remote with any wireless-enabled GoPro. The remote
can control up to 50 cameras at a time from up to 600ft (180m) away in
*
optimal conditions. Your camera recognizes only one remote at a time. The
Smart Remote is waterproof to 33ft (10m).
The distance from which you can control your camera with the remote varies
and depends on factors such as camera model, terrain, weather, obstructions,
and electromagnetic interference.
For information about using the Smart Remote with other GoPro cameras,
see gopro.com/smart-remote-setup.
Dependent on camera model and environmental conditions. Visit gopro.com for details.
*
PAIRING YOUR REMOTE AND YOUR FUSION
1. Power off the remote.
2. On your camera, complete these steps:
a. Press the Mode button repeatedly until you get to Settings
then press the Shutter button to select it.
b. Press the Shutter button
Connections .
c. Press the Mode button to highlight Connect, then press the Shutter
button to select it.
d. Press the Mode button repeatedly until you get to SmrtRC, then
press the Shutter button
begins pairing.
3. Power on the remote. If the remote was never paired with a camera, it
automatically begins pairing. Otherwise, press and hold the Settings/Tag
button for four seconds to begin pairing. Once the devices are paired, a
confirmation appears on each screen.
,
repeatedly until you get to
to select it. The camera automatically