Light (Led); Tips For Saving Energy - Siemens KD N Series Instructions For Use Manual

Hide thumbs Also See for KD N Series:
Table of Contents

Advertisement

Available languages

Available languages

en
Interior fittings
All variable parts of the appliance
can be taken out for cleaning.
Take out glass shelves
Pull the glass shelves forwards and take
out.
Take out shelves in the door
Fig. $
Lift shelves upwards and take out.
Taking glass shelf out of chiller
compartment
Fig. *
Press the holder upwards and take out
the glass shelf.
Note
Do not clean glass shelf of the cold
storage compartment under running
water.
Drawers in the refrigerator
compartment
Fig. ,
Pull out the drawer all the way, lift up
and remove.
To insert drawer, place the drawer on
the telescopic rails and push into
the appliance. Attach the drawer by
pressing it down.
Note
Before the vegetable drawer can be
taken out, the glass shelf above must be
taken out.
Taking out glass shelf above vegetable
container
Fig. +
The glass shelf can be taken out and
disassembled for cleaning.
Note
Before taking out the glass shelf, pull out
vegetable container.
20

Light (LED)

Your appliance features a maintenance-
free LED light.
These lights may be repaired
by customer service or authorised
technicians only.

Tips for saving energy

Install the appliance in a dry, well
ventilated room! The appliance should
not be installed in direct sunlight
or near a heat source (e.g. radiator,
cooker).
If required, use an insulating plate.
Allow warm food and drinks to cool
down before placing in the appliance.
Thaw frozen food in the refrigerator
compartment and use the low
temperature of the frozen food to cool
refrigerated food.
Open the appliance as briefly as
possible.
To avoid increased power
consumption, occasionally clean the
back of the appliance.
If available:
Fit wall spacers to obtain the indicated
energy rating of the appliance (see
Installation instructions). A reduced
wall gap will not restrict the function
of the appliance. The energy rating
may then increase slightly. The gap
of 75 mm must not be exceeded.
The arrangement of the fittings does
not affect the energy rating of the
appliance.

Advertisement

Table of Contents
loading

Table of Contents