Other Settings; Enabling The Ais Function; Setting Printer Property - JRC JHS-800S Instruction Manual

5.6 Other settings

The following describes concerning the AIS, printer and controllers.
5.6.1

Enabling the AIS function

When connecting the AIS to use the information for such as a DSC call, set the import condition to
ON as follows.
■ ■
Procedure
1 1 . .
1 .
From the main menu, touch the [SETUP]→ [AIS
FUNC] buttons to display the screen as shown at
right.
2 2 . .
2 .
After setting the IMPORT to ON, touch the [✓] button
to save it.
5.6.2

Setting printer property

When connecting the printers, configure the conditions as follows.
■ ■
Procedure
1 1 . .
1 .
From the main menu, touch the [SETUP]→ [PRN
PROP] buttons to display the screen as shown at right.
This menu includes the following settings.
STATE:
IP ADDRESS:
PORT:
DATA OUT
DIRECTION:
2 2 . .
2 .
After the setting is complete, touch the [✓] button to save them.
Printer use or not
Change the value if appropriate.
(172.016.060.181 as factory default setting)
Change the value if appropriate.
(09100 as factory default setting)
Printout setting of DSC messages
(AUTO or MANUAL)
Printout direction
(INVERT or UPRIGHT)
Settings & Registrations
5-15