Overheat Protection; Overdischarge Protection - Makita XWL01 Instruction Manual

Overheat protection

When the tool is overheated, the tool stops automati-
cally, and the battery indicator blink about 60 seconds.
In this situation, let the tool cool down before turning the
tool on again.
On

Overdischarge protection

When the battery capacity becomes low, the tool stops
automatically and the battery indicator of the depleted
battery cartridge will blink. If the product does not oper-
ate even when the switches are operated, remove the
depleted battery cartridge from the tool and charge it.
Blinking
Indicating the remaining battery
capacity
1
► 1. Battery indicator 2. Check button
Press the check button to indicate the remaining battery
capacities. The battery indicators correspond to each
battery.
Battery indicator status
On Off
Blinking
Off
2 1
Remaining
battery
capacity
Blinking
50% to 100%
20% to 50%
0% to 20%
Charge the
battery
Indicating the remaining battery
capacity
Only for battery cartridges with the indicator
► 1. Indicator lamps 2. Check button
Press the check button on the battery cartridge to indi-
cate the remaining battery capacity. The indicator lamps
light up for a few seconds.
Indicator lamps
Lighted
NOTE: Depending on the conditions of use and the
ambient temperature, the indication may differ slightly
from the actual capacity.
6 ENGLISH
1
Off Blinking
malfunctioned.
2
Remaining
capacity
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have