Command Overview - Toshiba VF-A7 Instruction Manual

Figure 4: Telnet Menu

8.3 Command Overview

The console provides standard access and configuration methods for the various
network parameters and application configuration parameters supported by the ETH-
100. The number and type of supported console commands may vary with different
console version and application version firmware. This section will present an
overview of the supported console commands.
It is important to note that unless otherwise indicated, each of these commands will
become effective immediately after it has been successfully entered. This may have
several repercussions; for example, if you change the IP address of the device via
the Telnet console, then you will lose the telnet connection to the device (as it was a
connection to the old IP address) and therefore must re-connect to the console if you
wish to continue changing parameters. Also note that the console commands are not
case-sensitive.
Help: This command shows the console version and an overview of all available
commands. As indicated in the returned help information, typing "Help <command>"
with a specific command will return help information specific to that command. Refer
to Figure 5 for the help command output via Telnet. All further display screens
shown in this manual will be from Telnet, although they will look identical when
accessed via the serial channel (MMI port).
22