Toshiba VF-A7 Instruction Manual page 24

Ethernet communications interface for the toshiba 7 series and 9 series adjustable speed drives

Hide thumbs Also See for VF-A7:

Table of Contents

Figure 5: "Help" Command Via Telnet

Echo: "Echo ON" (default setting) will echo typed characters back to the user.

"Echo OFF" will disable the echoing of typed characters.

Set: The "Set" command actually encompasses several subcommands, each of

which allows setting a different configuration parameter. To set a parameter, two

arguments are required: the parameter's name and the value to set it to. Figure 6

shows an example of changing the IP address of a device to 192.168.1.1. After this

command is entered, the device will then reconfigure itself to allow network access

via the IP address 192.168.1.1.

Figure 6: "Set" Command Overview and Implementation

Show: This command displays current configuration information. Some of this

information (IP Address, Netmask and Gateway) is configurable via the "set"

command. The "I/O Parameter" field lists the current console's primary

communication parameter (port number 23 for the Telnet console and baud rate

38400 for the serial console). The "Firmware Ver" field indicates the current

application firmware version of the ETH-100. Refer to Figure 7.

Table of Contents

Eth-100