• Addresses with all bits of the host address are "0" or "1"
The value of the subnet mask consists of a series of "1" from the most
significant bit.
3.2.2 Station address
Use the station address setting switches to set the station address.
Any station address can be set; however, it must be unique within the system.
The available setting range for station addresses is from 01(h) to FE(h)(1 to
254).
When the IP address type is [Any], it has precedence over the value of the
station address setting switches. In this case as well, it is recommended
matching the lowermost value of the specified IP address (5 in the case of
172.16.64.5) and the value of the station address setting switches. For [Any],
set the station address in the dotted decimal notation using the engineering
tool.
3.2.3 Overview of multicast address
The JTNI supports 15 multicast addresses.
Support addresses are as follows:
Any of the 15 addresses can be selected and registered by using one JTNI.
Registration to the JTNI is performed with the engineering tool.
For the registration method, refer to "3.3 Setting with the engineering tool."
Table3-3 Multicast address
No.
Multicast address
1
225.224.0.1
2
225.224.0.2
3
225.224.0.3
4
225.224.0.4
5
225.224.0.5
6
225.224.0.6
7
225.224.0.7
8
225.224.0.8
9
225.224.0.9
10
225.224.0.10
11
225.224.0.11
12
225.224.0.12
13
225.224.0.13
14
225.224.0.14
15
225.224.0.15
Unified Controller nv-pack series TC-net 100(JTNI)Extended card Instruction Manual
3.2 Network Parameter Setting
15