Table of Contents
Advertisement
In-Circuit
Configuration
Options
Running the
Emulator from
Target Reset
3-10 In-Circuit Emulation
The H8/338 emulator provides configuration options for the following
in-circuit emulation issues.
Refer to the "Configuring the Emulator" for more information on these
configuration options.
Using the Target System Clock Source
You can configure the emulator to use the external target system clock
source.
Enabling/Disabling /NMI input from the target system
You can configure the emulator to accept the /NMI input from the
target system.
Enabling/Disabling /RES input from the target system
You can configure the emulator to accept the /RES input from the
target system.
You can specify that the emulator begins executing from target system
reset. When the target system /RES line becomes active and then
inactive, the emulator will start reset sequence (operation) as actual
microprocessor. To specify a run from target system reset, select:
run from reset <RESET>
The status now shows that the emulator is "Awaiting target reset".
After the target system is reset, the status line message will change to
show the appropriate emulator status.
Advertisement
Table of Contents
