Advertisement
4. Installation of Fitting
Mounting the pole
Place the pole with the upper pole bearing
into the cam plate. Push both connection
rods completely to rear while turning the
pole approx. 90° to the left until the guide
roller is positioned on the outer edge of
the cam plate and the axle firmly clicks
into position. This prevents lifting of the
pole out of the cam plate.
Connecting the upper pole bearing
Now connect the upper pole bearing to
either the top mounting bracket (frameless
cabinets with specified top mounting
bracket) or . . .
to the cabinet top (face frame cabinet
without specified top mounting bracket)
and fasten with screws (customer
supplied).
The pole should now easily turn 360
degrees.
6
Advertisement
