Advertisement
Quick Links
Advertisement
Summary of Contents for Hafele Suzie-Q 541.35.520
- Page 1 Mounting Instructions Item No.: 541.35.520/521/522/420/421/422 Revolving Corner Unit...
- Page 2 In addition to these general mounting These instructions also indicate if additional instructions, please refer to the fitting adjustments to the cabinet design are neces- instructions, where the individual drilling sary. Please contact your Häfele Hardware dimensions for the cabinet bottom, cabinet Consultant if fitting specifications are neces- top, side walls and cabinet doors are specified.
- Page 3 1. Preparing cabinet bottom and side all/cabinet top Preparing cabinet bottom Drill three holes into the cabinet bottom Specification Document according to the illustration included in the fitting instructions. If a top mounting bracket is specified For cabinets with cabinet top: (mainly frameless cabinets): Drill one 10 mm hole into the cabinet top Drill two holes 12 mm deep with 5 mm bit...
- Page 4 2. Assembling side panels and cam plate Assembling side panels After having drilled all holes, assemble the side panels. Mounting of cam plate Press the cam plate into the drilled holes in the bottom of cabinet interior and fasten with four 3.5 x 30 mm (#6 x 1 1/8’’) flat head screws (customer supplied).
- Page 5 3. Installation of top mounting bracket only if specified If cabinet has a top, proceed to step 4.Installation of fitting, (page 6). (mainly face - frame cabinets) Installation of top mounting bracket is only applicable if cabinet has no top. (mainly frameless cabinets) Fasten top mounting bracket with 6.2 x 10.5 mm Euro flange head screws (customer...
- Page 6 4. Installation of Fitting Mounting the pole Place the pole with the upper pole bearing into the cam plate. Push both connection rods completely to rear while turning the pole approx. 90° to the left until the guide roller is positioned on the outer edge of the cam plate and the axle firmly clicks into position.
- Page 7 5. Mounting doors Preparing doors Drill 4 holes into the doors according to Specification Document the illustration included in the fitting instructions. Screwing door brackets onto the doors First screw the lower door brackets (unhanded) and then the upper door brackets (left and right!) onto the doors (customer supplied).
- Page 8 5. Mounting doors Hanging doors onto the door holders: Hang doors onto upper door holder and lower door holders with the locating pins. Clip the connecting rods into the bottom door bracket. Securing the door To avoid unintended unhinging of the door, attach securing caps onto lower locating pin.
- Page 9 6. Mounting shelves / Fixing transport lock Plastic Shelves, Arena Shelves, Chrome/Wire Shelves or Pro Arc Shelves: Attach shelves to pole according to the mounting instructions supplied with the shelves. Wooden shelves: If you use your own wooden shelves, you need shelf supports supplied by Häfele.
- Page 10 7. Mounting of support device / Transport notices If you use a top mounting bracket: Do not suspend the cabinet from the top mounting bracket. Do not bend the top mounting bracket. Do not put weight on the top mounting bracket (i.e. do not stack other cabinets on top for transport).
- Page 11 8. Adjusting the doors Adjusting the Doors: The doors can be adjusted independently in all directions. Before making adjustments, make sure the corner cabinet is aligned exactly. If you use adjustable cabinet feet, special attention should be paid to adjusting the middle foot for support of the pole weight. When adjusting, first correctly align the right door following the steps illustrated below.
- Page 12 B-1= weakest spring force. This is increased through the combinations A-1, B-2 to the strongest spring force of A-2. The tension spring can only be repositioned when the fitting is removed. 3901 Cheyenne Drive P.O. Box 4000 Archdale, NC 27263 1-800-423-3531 www.hafele.com...