Procedure
15
16
17
18
1
Preparing to Install the Kit
No Parts Required
Procedure
Note: If you are installing the remote hydraulics manifold
kit on a Workman model with a serial number in the range of
240000000 through 249999999, you must replace the switch
in this kit. Purchase the new switch (Toro Part No. 105-0023)
from your Toro Distributor and install the switch.
1. Move the machine to a clean and level surface.
2. Shut off the engine, set the parking brake, and remove
the key from the key switch.
3. Remove the bed from the machine; refer to the
Operator's Manual for your Workman model for the bed
removal procedure.
4. Disconnect the battery as follows:
A. Squeeze the battery cover to release the tabs from
battery base
(Figure
Description
No parts required
No parts required
No parts required
No parts required
1).
Figure 1
Qty.
Install the seat shroud, ROP shield, and
–
coolant tank.
–
Install the seats and center console.
–
Install the hood.
–
Install the bed.
B. Remove the battery cover from the battery base
(Figure
1).
C. Remove the terminal of the positive battery cable
from the battery post
Note: Ensure that the terminal positive battery
cable does not touch the battery post.
1
2
1. Terminal cover
2. Positive terminal
5. Bleed the hydraulic pressure from the machine by fully
moving the lift control for the cargo box forward and
backward several times
Note: You must bleed the hydraulic pressure from the
machine with the engine shut off.
4
Use
(Figure
2).
3
4
G022071
Figure 2
3. Battery post
4. Battery
(Figure
3).