Turning On/Off - Salora 60BFH3800 Manual

Turning the projector On/Off
Turning the projector on:
1) Install the two new batteries into the remote control before using the projector.
2) For switching the projector on, you need to press the power switch at the back, the
indicator light will turn red.
3) Press the power button on the top panel or the remote control, the indicator light
will turn blue.
4) After a few seconds, the lamp will begin to work.
5) When you use the projector for the first time, the image may appear blurry or
distorted. Please refer to the Image Adjustment chapter for instructions to adjust the
image quality.
6) You can always reset the system parameters at any time. Please refer to the menu
Setting chapter.
Turning the projector off:
1) When the projector is in operation, press the power key and the projector will enter
standby mode.
2) When the projector is in standby mode, the auto protection system will be activated.
If you would like to restart the projector, press the power key again.