Selecting A Waveband; Station Tuning; Automatic Seek Tuning; Manual Tuning With - Blaupunkt DRESDEN RCR 128 Operating Instructions Manual

Selecting a waveband

With this car radio you can select between
the following wavebands:
FM 87,5 - 108 MHz
MW 531 - 1602 kHz
LW153 - 279 kHz
(Dresden RCR 128 without MW, LW) .
• Select the desired waveband by press-
ing the BA/TS button.

Station tuning

Automatic seek tuning

• Press / ; the car radio will automati-
cally search for the next station.
If you hold / pressed up or down on the
rocker switch, seek tuning will speed up in
the upwards or downwards direction.
Automatic seek tuning
Up
Down
<< / >> Up/down in short intervals
(on FM only if "AF" is switched off)
26
Manual tuning with << >>
You can also tune into a station manually.
Requirement:
AF and PTY must be switched off (i.e. the
symbols do not light up in the display).
If necessary, deactivate these functions:
• Press AF·TA or PTY.
Manual tuning:
• Press << >>; the frequency will change
in short intervals in the downwards or
upwards direction.
/
If you hold << >> pressed to the left or the
right on the rocker switch, the frequency
scan will speed up.
Scrolling through the broadcast-
ing networks (FM only)
You can use the << >> buttons to tune into
stations in your reception area.
If it is possible to receive several pro-
grammes in the same broadcasting network,
you can scroll through them in the forwards
direction by pressing >>, or backwards
using the << button, e.g. NDR 1, 2, 3, 4,
N-JOY, ...
For this to work properly you must have al-
ready tuned into the stations at least once
and "AF" must be active (lights up in the dis-
play).
To do this, you can start the Travelstore seek
operation:
• Press BA/TS for 2 seconds; the sys-
tem will start to run through the fre-
quency band.
If "AF" is not lit up,
• Hold AF·TA down. A beep sounds and
"AF" appears.
This fulfils the requirements for selecting
stations with << >>.
Switching between the memory
banks (FM)
You can switch between the memory banks
1, 2 and T in order to store stations and re-
call them later.
The currently selected memory bank ap-
pears in the display.
• Press the BA/TS button as many times
as necessary until the desired memory
bank lights up in the display.

Storing stations

On FM, you can store six stations on the
preset buttons 1, 2, 3, 4, 5, 6 for each of the
memory banks (1, 2, T).
On MW/LW, you can also store six stations
each (Dresden RCR 128 without MW, LW) .