Siemens SIMATIC S7-1500 Manual page 11

Properties
The PS 60W 24/48/60VDC HF power supply module supports the use of additional modules.
Advantage over the "standard" power supply module:
To save a higher volume of data retentively in case of power failure, the PS 60W
24/48/60VDC HF supplies power to the CPU.
The PS 60W 24/48/60VDC HF has the following properties:
● Technical properties
– Rated input voltages 24/48/60 VDC
– Output power 60 W
– Power failure backup
– Electrical isolation to the bus, safe electrical separation according to EN 61131-2
The module supports the following functions:
Table 2- 1 Version dependencies of the module functions
Function
Firmware update
Identification data I&M0 to I&M4
Configuration in RUN
Diagnostic alarms
Diagnostic interrupts
Only configurable on LH side next to interface
module / CPU
Extended retentivity of the CPU data area in
the event of a power failure
Accessories
The following components are supplied with the power supply module:
● Power connector
● U connector
These components are also available as spare parts.
Power supply module PS 60W 24/48/60VDC HF (6ES7505-0RB00-0AB0)
Manual, 01/2019, A5E39450002-AB
Firmware version
of the module
(TIA Portal) as of
V1.0.0 or higher
V1.0.0 or higher
V1.0.0 or higher
V1.0.0 or higher
V1.0.0 or higher
V1.0.0 or higher
V1.0.0 or higher
(only with CPU S7-1500
firmware version V2.1 or
Configuration software
STEP 7 GSD file in STEP 7
(TIA Portal) V12 or higher,
V14 SP1 or STEP 7 V5.5 SP3 or
X
X
X
X
X
(PROFINET IO only)
X
X
higher)
Product overview
2.1 Properties
higher
X
---
11