Table of Contents
Advertisement
OPERATION
1.
When the auto-deceleration switch is pressed and the au-
to-deceleration function is turned ON, the mode is dis-
played in the center of the monitor display, and after 2 sec-
onds, the screen returns to the standard screen.
2.
On the standard screen, auto-deceleration indication lamp
lights up.
(When the auto-deceleration is OFF, the indication lamp
goes out.)
TRAVEL SPEED SELECTOR SWITCH
•
When loading to or unloading from a trailer, always drive the machine at low speed (set it to "Lo")
and never operate the travel speed selector switch during travel.
•
If the travel speed is switched between "Hi" and "Lo" when the machine is traveling, the machine
may deviate to one side, even when traveling in a straight line. Stop the machine before switching
the travel speed.
Travel speed selector switch is used to select the travel speed
from 2 stages.
"Lo" lights up: Low-speed travel
"Hi" lights up: High-speed travel
When the engine is started, the speed is automatically set to
"Lo".
Each time that the switch is pressed, the display changes "Lo"
→"Hi"→"Lo" in turn.
Even if the travel speed is set to high-speed ("Hi"), when the
machine travels on soft ground or uphill and travel power is
needed, the system automatically shifts down to low-speed
travel ("Lo") and you do not need to operate the switch. In this
case, the travel speed on the monitor display stays lit at "Hi"
(high-speed).
k
k
WARNING
WENAM00042
EXPLANATION OF COMPONENTS
3-43
Advertisement
Chapters
Table of Contents
