Physical Interface Setting; Interface Configuration - Advantech ICR-1601 Configuration Manual

Physical Interface Setting

Go to Basic Network > WAN & Uplink > Physical Interface tab.
The Physical Interface allows user to setup the physical WAN interface and to adjust WAN's behavior.
When Edit button is applied, an Interface Configuration screen will appear. WAN-1 interface is used
in this example.

Interface Configuration:

Interface Configuration
Item Value setting
1. A Must fill setting
2. WAN-1 is the
Physical Interface
primary interface and
is factory set to Always
on.
Operation Mode
A Must fill setting
VLAN Tagging
Optional setting
Description
Select one expected interface from the available interface dropdown list. It
can be 3G/4G, Ethernet or WiFi Module.
Depending on the router model, Disable and Failover options will be
available only to multiple WAN routers. WAN-2 ~ WAN-4 interfaces are only
available to multiple WAN router.
Define the operation mode of the interface.
Select Always on to make this WAN always active.
Select Disable to disable this WAN interface.
Select Failover to make this WAN a Failover WAN when the primary or the
secondary WAN link failed. Then select the primary or the existed
secondary WAN interface to switch Failover from.
(Note: for WAN-1, only Always on option is available.)
Check Enable box to enter tag value provided by your ISP. Otherwise
uncheck the box.
Value Range: 1 ~ 4095.
Note: This feature is NOT available for 3G/4G WAN connection.
12
ICR-1601