Fresca FFT2602CH Installation Instructions

Extended single-lever faucet

INSTRUCTIONS

FFT2602CH

Extended single-lever faucet

Important

We recommend that this product is installed by a qualified professional contractor.

●

Please check this product immediately to ensure that it has not been damaged and is complete.

●

Please flush the water system to ensure that no debris or any other impurities can enter the taps.

●

Turn off water supply before commencing work.

●

Please read these instructions carefully and keep for future reference.

Before use: Unscrew the Aerator and allow the water to run freely for 5 minutes. Then screw the filter back in place.

Periodically: Unscrew the Aerator and remove. Rinse it with running water until any loose debris is cleared. Then replace the Aerator

and tighten.

Aerator

Maintainance

We do NOT recommend you use any household cleaners to clean the product. Because these cleaners change substance or formula

too frequently. The product should always be cleaned only with soapy water and rinsed with clean water and dried with a soft cloth.

Table of Contents

Do you have a question about the FFT2602CH and is the answer not in the manual?

Page 1 INSTALLATION INSTRUCTIONS FFT2602CH Extended single-lever faucet Important We recommend that this product is installed by a qualified professional contractor. ● Please check this product immediately to ensure that it has not been damaged and is complete. ● Please flush the water system to ensure that no debris or any other impurities can enter the taps.
Page 2 Dimensions Unit:inches 3.7″ 4.5″ Installation FAUCET HANDLE CARTRIDGE ADAPTOR FAUCET GRUB SCREW O-RING RETAINING CARTRIDGE COVER RUBBER WASHER To remove the cartridge. BRASS WASHER First shut off the water supply to the tap. 1: Pull out the cap from the handle. FEMALE SCREW 2: Loosen the grub screw in handle, but do not remove it.