Fresca FFT3001CH Installation Instructions

Single-lever faucet

INSTRUCTIONS

FFT3001CH

Single-lever faucet

We recommend that this product is installed by a qualified professional contractor.

●

Please check this product immediately to ensure that it has not been damaged and is complete.

●

Please flush the water system to ensure that no debris or any other impurities can enter the taps.

●

Turn off water supply before commencing work.

●

Please read these instructions carefully and keep for future reference.

Before use: Unscrew the Aerator and allow the water to run freely for 5 minutes. Then screw the filter back in place.

Periodically: Unscrew the Aerator and remove. Rinse it with running water until any loose debris is cleared. Then replace the Aerator

and tighten.

Maintainance

We do NOT recommend you use any household cleaners to clean the product. Because these cleaners change substance or formula

too frequently. The product should always be cleaned only with soapy water and rinsed with clean water and dried with a soft cloth.

Aerator

Table of Contents

Need help?

Do you have a question about the FFT3001CH and is the answer not in the manual?

Page 1: Installation Instructions
INSTALLATION INSTRUCTIONS FFT3001CH Single-lever faucet Important We recommend that this product is installed by a qualified professional contractor. ● Please check this product immediately to ensure that it has not been damaged and is complete. ● Please flush the water system to ensure that no debris or any other impurities can enter the taps.
Page 2 Dimensions Unit:inches 6.1″ 1.6″ Installation ALLEN FAUCET GRUB SCREW HANDLE CARTRIDGE COVER RETAINING SUPPLY LINES CARTRIDGE MALE SCREW O-RING FAUCET To remove the cartridge. First shut off the water supply to the tap. RUBBER WASHER 1: Pull out the cap from the handle. 2: Loosen the grub screw in handle, but do not remove it.