Advertisement
2. GETTING STARTED
2.1 Shipping Weight
B100 weight: 12 lbs. (5.44 kg)
B200 weight: 19 lbs. (8.61 kg
2.2 Unboxing
Our packaging is designed to protect the luminaire during shipping. Please inspect to confirm it was
not damaged in during the process.
2.3 Handling
Once unpacked, the luminaire can become damaged if mishandled. Do not stack luminaires after
unpacking. Protect the remote phosphor plate from scratching.
2.4 Package Contents
Light fixture – assembled
-
-
Installation Instructions
3. INSTALLATION
The B100 and B200 light fixtures are designed for high/low bay mounting using lighting hooks and share
common mounting procedures:
D
1) Loosen set bolt on mounting hook so there is enough room to install hook on to mounting point.
2) Place hook over the mounting point
3) Tighten the set bolt on the mounting hook to 10 ft-lbs.
CAUTION: make sure the mounting point is capable of permanently supporting the weight
of the luminaire. Follow applicable codes for mounting fixtures.
The B200 has adjustable lighting spread that changes the photometric footprint of the luminaire. Only
qualified personnel should make these changes. To adjust:
1) Loosen bolts on side of light housing (shown in Fig. 1 below)
C
2) Pivot lighting module to desired angle
3) Tighten Angle Adjustment bolt to 15 ft-lbs. to lock in adjustment.
10/25/2013
No part of this publication may be reproduced without the prior agreement and written permission of Horner Lighting Group, LLC. Information in this document is subject to change without notice.
4
Figure 1 - Side view of A200: angle adjustment bolt location.
Pivot Points
LMAN0007-01-EN
ETG-B100/B200 INSTALL SHEET
9.12
3
Page 2 of 3
Advertisement
