On Completion Of Use - Hitachi AW130 Handling Instructions Manual

English
3. Pull the trigger (Fig. 20)
Hold the trigger gun fi rmly in both hands, point the nozzle
at the item to be washed, and then pull the trigger.
The high-pressure water jet will spray out.
Adjust the nozzle between "Jet" and "Spray" in
accordance with need.
Trigger stopper (Fig. 21)
The trigger gun is fi tted with a trigger stopper to prevent
the trigger from being pulled.
The trigger is locked and released by pressing the stopper in
the direction shown by the arrows.
NOTE
Lock the trigger with the trigger stopper during pauses and
after washing has been completed.

ON COMPLETION OF USE

Once the targeted item has been washed, drain the residual water from the washer and store it in
a well-ventilated location to dry.
There are cases in which water left in the hose may freeze during the winter, so drain as much
water as possible and store it indoors.
WARNING
Make sure all residual water is drained from the washer, the trigger gun and the
hose, etc., after use.
Failure to observe this may result in freezing, leading to malfunctions.
1. Draining water from the washer
(1) Stop the water supply.
(2) Set the switch to "ON" and pull the trigger on the trigger gun to drain the water from the
inside of the washer. Continue this until water is no longer discharged (approximately 30 to
60 seconds.)
(3) Press the trigger stopper on the trigger gun to lock it in place.
2. Set the switch to "OFF".
(1) Switch off the washer.
(2) Unplug the power cord from the mains socket.
NOTE
Leaving the washer switched on may result in dry operations, leading to malfunctions.
36
Fig. 20
Push
Trigger
stopper
Trigger
Lock
Push
Trigger
Trigger
stopper
Release
Fig. 21