Inspections Prior To Use; Attaching Parts - Hitachi AW130 Handling Instructions Manual

English
7. Attaching the handle (Fig. 3)
Use a Phillips screwdriver to fi rmly tighten all four
screws.

INSPECTIONS PRIOR TO USE

WARNING
Check the following before using the washer. Check the items listed in 1 and 2
before plugging into the power socket.
1. Check to make sure the switch is at the "OFF" position (Fig. 4)
Plugging the washer into the power socket
with the switch set at "ON" will cause the
washer to immediately begin operating, which
may result in unexpected injuries.
2. Check the power supply
Only use a rated voltage.
Do not use motor engines are direct current.
Failure to observe this will not only result
in damage to the washer, it is also very
dangerous.
3. Check the power socket
If the power socket is loose or the plug is easily dislodged, it needs to be repaired.
It is dangerous to use it in this condition. Consult with your local electrical engineering
outlet.

ATTACHING PARTS

Make sure all parts are correctly attached in the following sequence in order to guarantee safe
usage.
WARNING
Switch off the washer and disconnect it from the power socket without fail to
prevent unexpected accidents.
1. Attach the water feed connector to the water feed
inlet on the washer (Fig. 5)
Remove the cap on the washer's water feed inlet and
fi rmly attach the water feed connector.
Loose connections may result in water leaks.
Handle
Screw
0
Water feed inlet cap
Water feed
connector
30
Fig. 3
1
Power plug
Fig. 4
Water feed inlet
Fig. 5
Screw