Washing - Hitachi AW130 Handling Instructions Manual

English
3. Starting the suction hose water suction process (Fig. 15)
Sink the strainer hose set into a container
fi lled with water.
Start off the suction process (introduce water
to the suction hose.)
NOTE
○ Do not use anything other than clean water
(river or pond water, muddy water containing
sand granules.)
Failure to observe this may result in malfunctions.
○ Set the switch at "ON" without the nozzle attached.
Failure to observe this may result in dry operations, leading to malfunctions.
4. Insert the one-touch joint into the water feed connector (Fig. 16)
Withdraw the one-touch joint from the
accumulated water and insert it into the water
feed connector on the washer while making
sure that the water inside the hose does not
escape.
5. Check to make sure the water is fl owing
out (Fig. 17)
(1) Connect the trigger gun from which the
nozzle has been removed to the high-
pressure hose.
(2) Plug in the power socket and set the switch
to "ON".
(3) Pull the trigger gun's trigger, and then set the
switch to "OFF" after checking that suffi cient
water is fl owing out.
6. Attach the nozzle.
NOTE
Set the switch at "OFF" if water does not fl ow out within two minutes.
Failure to observe this may result in malfunctions (dry operations.)
7.

Washing

Set the switch at "ON" and pull the trigger gun's trigger to commence washing.
8. Cleaning
Remove all dirt from the strainer's grill, wash it with water and store it after it has dried.
WASHING
WARNING
○ Do not switch the washer on while the trigger is being pulled.
Failure to observe this may result in high-pressure water being sprayed
immediately, leading to unexpected accidents.
○ Do not point the nozzle at people or animals.
Failure to observe this may result in injury.
Strainer
Water feed connector
One-touch joint
Suction hose
Trigger gun
Suction
hose
Strainer
Accumulated water
Fig. 17
34
Accumulated water
Fig. 15
Fig. 16
Trigger
High-pressure
hose
Switch