Table of Contents
Advertisement
www.BuilderDepot.com
http://www.advancedactuators.com
Section 3 Pre-installation
3.1 Mark and bore holes on the door
3.11 Use the following steps to properly mark holes on door for
drilling:
1) Remove existing handle set.
2) Cut out the two, 3/8" holes on the Installation Template that
correspond to your existing backset (2 3/8" or 2 ¾").
ReliTouch® User Manual
6
Advertisement
Table of Contents
Need help?
Do you have a question about the ReliTouch RT-201 and is the answer not in the manual?