Advertisement
X2 Jumper Settings
IDE Device Installation
Wicher 508i's built-in IDE controller uses the IDE44 port that is compatible with devices such as hard drives and IDE-
CF/IDE-SD adapters. When installing any IDE device, please ensure the correct orientation of the pin no. 1 by following the
labeling on the Wicher 508i card.
IDE connector location
More information on Wicher 508i and other 7-bit products can be found on our website, available at:
Wicher 508i
Position 0 – enable / disable turbo card
Position 1 – enable / disable RAM
Position 2 – enable / disable IDE controller
https://7-bit.pl
6
Advertisement
