Qanon D Series User Manual page 6

OUT1
GAIN +0.0dB
PEQ: 1 F: 40.2 Q: 3.00
G: 0.0dB PEAK ON
OUTLINK 1:√ 2:X 3:X
4:X 5:X 6:X 7:X 8:X
OUT1
DEALY 0.000ms
HP: 19.6 BYPASS
LP: 20K15 BYPASS
OUT1 MATRIX SELECT
A: √ B: X C: X D: X
OUT1 A: +0.0 B: +0.0
MIX C: +0.0 D: +0.0
COMP TH: +20.0 R: 1.0
K: 0dB A: 50 RT: 1500
LIMIT TH: +20.0dB
AT: 50ms RT: 500ms
OUT1
PHASE 0
Press OUTPUT EDIT enter the settings as follow
Default preferred option is gain, the scale is- 60dB--12dB.
Press "PEQ", enter PEQ PARAMETER SETTING: "PEQ" current number is 9,
the scale of "F" is 20Hz-20kHz, "Q" is 0. 4-128 "G" is -12dB- +12dB, the style
of filter are Peak, Low-shelf, High-shelf, High-cut, Low-cut, Allpass1,
Allpass2, Bypass(ON/OFF).
Press "LINK", enter linking adjustment selection: if the current channel is "OUT1",
you can choose OUT2, OUT3, OUT4, OUT5, OUT6, OUT7, OUT8
channel to adjust parameter simultaneously.
Press "DELAY" enter delay parameter setting: the scale is 0-680mS, 0-234m 0-
766ft .
Press "X-OVER" enter low-high pass parameter setting: the scale of "HP" is
20Hz-20kHz, "LP" is 20Hz- 20kHz, 3 different slanting rate for low/high pass
filter: Butterworth, Bessel, Linkwitz- Riley, Slanting rate is -6dB--48dB.
Press "MATRIX" enter matrix setting, all the output channel can choose one or
several input signal freely.
Press the second time "MATRIX" key, enter matrix route output gain
interface: factory default is 0dB, adjustment scale is -60dB-0dB.
Press "COMP/GATE" enter compressor setting: the scale of threshold is -60dB~
+12dB, startup time is 1-999ms, attached time is 10-3000ms, ratio is 1:1, 1:10-LIMIT.
Press the second time "COMP/GATE" key enter peak limiter parameter
interface: threshold "T" adjustment scale is -90dB-+20dB, attached time "AT"
adjustment scale is 1-999ms, release time "RT" adjustment scale is
10-3000ms.
Press "PHASE" enter phase parameter setting: the scale is 0/180.
Digital Matrix Processor
,
4