Yamaha WaveRunner GP1300R Supplementary Service Manual page 113

INSP
ADJ
4 1
3 2
POWER UNIT
a
2. Measure:
• YPVS cable slack a
Out of specification → Adjust.
YPVS cable slack:
0.5–1.5 mm (0.02–0.06 in)
3. Adjust:
• YPVS cables 1 and 2
Adjustment steps:
• Loosen locknuts 1 and 2.
• Turn adjusters 3 and 4 in until there is
slack in the cables.
• Align the hole a in the pulley with the
hole in the cylinder.
• Insert a 4 mm (0.16 in) diameter pin
through the pulley and cylinder holes.
• Turn adjusters 3 and 4 in or out until
the specified slack is obtained.
Turn in
Turn out
• Finger tighten locknuts 1 and 2.
• Remove the pin.
• Start the engine, and then turn it off.
• Check the alignment of the holes.
• If the holes are aligned correctly, tighten
the locknuts.
• If the holes are aligned incorrectly, repeat
the adjustment steps.
3-11
Slack is increased.
Slack is decreased.
E