Advertisement
Installing the camera on a ceilling with pipeline
Secure the mounting bracket on the place you want to mount it
after combining the mounting bracket with the pipeline.
Hole for 3/4 pipe (JIS B 0202-1966)
Ø5 tapping screw x 4 (supplied)
Connect power input and video output cables with the
each cable from pipeline.
Secure the main body on mounting bracket.
M4 machine screw x 4
4
2. ADJUST THE PANNING, TILTING WHILE WATCHING THE MONITOR
1) After mounting the camera on a ceiling, adjusting the panning angle for better
monitoring area by rotating the pan base.
2) And then adjust the tilting angle by rotating the tilt base.
70˚
170˚
Pan Base
-170˚
Notes
• After loosening Pan or Tilt Base
holding screws, adjust its angle.
And then tighten screws again.
Tilt Base holding screw
• In case of adjusting the tilting, do not take the lens for preventing physical shocks. Please take the Tilt Base.
3. ADJUST THE ZOOM / FOCUS
1) Loosen the zoom(focus) handle.
2) Adjust the zoom(focus) by moving the
zoom(focus) handle to TELE(FAR) or
WIDE(NEAR).
3) Tighten the zoom(focus) handle
after adjustment.
5
4. REINSTALL THE DOME COVER AND SHIELD CASE TO THE MAIN BODY
Mounting Bracket
Shield Case
Tilt Base
CONNECTION
Use AC 24V / 300mA or DC 12V / 500mA power source.
• Connecting to Power
Pan Base holding screws
(Color : Silver)
AC 24V
/ DC 12V
Focus Handle
Zoom Handle
Main Body (Camera)
Dome Cover
AC 24V
DC 12V
Black (Neutral)
Black (-)
White (Live)
White (+)
Green (Frame Ground)
Green (Frame Ground)
P/No. : 6809-0022-01A
VAN 04. 1
6
Advertisement
