Tektronix 549 Instruction Manual page 75

Dm
17. Patch cord, about 18 inches long, BNC to banana
plug-
18. Adjustment tools
Description
a. Insulated screwdriver, 1 '/* inch
shaft, non-metallic
b. Screwdriver, inch bit
c. Tuning rod, 5 inches
d. Alignment, tool kit
Includes:
Handle
Insert, for inch (ID) hex cores
Insert, with screwdriver tip
e. Hexagonal Key wrench, y t4 inch
f. Hexagonal key wrench,
CALIBRATION RECORD AND INDEX
This Abridged Calibration Procedure is provided to aid
in checking (he operation of the Type 549. It may be used
as a calibration guide by the experienced calibrator, or it
may be used as a calibration record. Since the step num­
bers and titles used here
®i
A
C
ft®. 6-2. Adjusting (poll required for calibrating (ho Typo 549.
Te k tro n ix
Pa rt No.
003-0000-00
003-0192-00
003-0301 -00
003-0007-00
003-0307-00
003-0310-00
003-0334-00
003-0106-00
003-0090-00
inch
correspond to those in the
D
ij i
complete Calibration Procedure, the following
serves as an index to locate a step in the complete Calibra­
tion Procedure. Characteristics are those listed in the Char­
acteristics section of tho Instruction Manual.
Type 5 4 9 Se ria l No.---- --------
C a lib ra tio n Date
H 1- Adjust — 150 Volt Power Supply (page 6-7)
Q 2. Check Low Voltage Power Suppy Regulation and
Ripple (page 6-7)
Q 3. Adjust High Voltage Power Supply (page 6-8)
—3700 Volts, ± 1 0 0 volts.
□ 4. Adjust Intensity Range (page 6-8)
Spot just visible on screen with Intensity control fully
clockwise.
f~l 5. Check High Voltage Regulation [page 6-8)
No trace blooming
changed through 103.5 to 126.5 VAC.
(~| 6. Adjust Graticule Position and Check Scan Area (page
6 8
- )
Position center graticule line to the slit between
upper and lower storage target. Scan area at least
6 X 1 0 c m .
Calibration— Type 549
B
D m
E
procedure
----
when input line voltage
6-3
is