Table of Contents
Advertisement
CCZ254comb.QX33
4/6/99 9:01 PM
A status display, which includes the current time, channel, and
other information (see illustration of the status display at right),
will appear when you press the STATUS/EXIT button or certain
function buttons. You can bring up the status display at any time
by pressing the STATUS/EXIT button. Remove the status display
by pressing this button again. The contents of the status display
may vary.
ON MODE:
Whenever a function button (REW(ind)/
pressed, the status display will appear for five seconds.
COUNTER ONLY MODE:
When a function button (REW(ind)/
pressed, the status display will appear for five seconds. After five
seconds, only the counter will remain on-screen. To remove it,
choose ON or OFF in the ON-SCREEN MODE menu. (There
is an exception. When you press the STOP/
tus display will appear for five seconds, then disappear.)
OFF MODE:
The status display will not appear when you press a function
button. The channel number will appear briefly when you select
a channel if channels are programmed.
To choose an ON-SCREEN MODE, follow the steps below.
1
Press the COMBI button, then press the MENU button.
2
Press the PLAY/
VCR SETUP. Then, press the F.FWD/B button.
3
Press the Number 3 button to select ON-SCREEN
MODE.
4
Press the Number 1 button to select ON, the Number 2
button to select COUNTER ONLY, or the Number 3 but-
ton to select OFF. Your selection will appear on-screen.
5
Press the STATUS/EXIT button.
Page 29
, PLAY/ , etc.) is
s
, PLAY/ , etc.) is
s
button or the STOP/
On-Screen Status Displays 29
Channel
button, the sta-
button to select
• If the channel you select has no
broadcast, the screen will be solid
blue.
• You cannot view closed captions
during recording or tape playback if
COUNTER ONLY is selected at step
4. Details are on pages 45 - 46.
Function
Button
Pressed
Time
12:00 AM
STOP
CH10
SLP
M 1:23:45
Counter
Tape
and
Speed
Counter
Memory
Helpful Hints
Advertisement
Table of Contents
