Related Manuals for Environmental Instruments ES008-M
Summary of Contents for Environmental Instruments ES008-M
- Page 1 Micromanometer User’s Manual Models ES008-M and ES008-MXS (Version 1.3 and above) January 2020...
-
Page 2: Table Of Contents
Table of Contents 1. Device Overview....................3 2. Basic Operation....................5 3. OLED Screen Overview...................8 4. Changing Batteries..................10 5. Connecting Sampling Tubing.................11 6. The App......................11 7. Feedback......................11... -
Page 3: Device Overview
1. Device Overview Figure 1.1 An overview of the front face of the EIC micromanometer is given in Figure 1.1. The front face includes: ● Advertising Name – it shows up in the scan list; ● OLED screen – display screens: live or an average of 10 seconds pressure readings in unit of Pascal or inH2O, and device information;... - Page 4 ● Port 1 & 2 – the manometer measures the pressure differences between these two ports; ● Button – control device to turn on and off, to toggle OLED screens and to manually set zeros; ● Operation Sticker – indicates button operations.
-
Page 5: Basic Operation
2. Basic Operation Basic operation of the EIC manometer is outlined in the following steps: 1) There should 2 new AA batteries in the device when you receive the manometer. The manometer should be in sleep mode. To start the manometer, press and hold the button (for more than 3 seconds) until OLED starts displaying Note(i) - Page 6 OLED. ES008-M and ES008-MXS have different button operations: Button Press ES008-M ES008-MXS Time: Short (<2s) Toggle Screens Long (2~5s) “Release to Zero” “Release to Shunt Down” Extra Long (>5s) “Release to Shunt “Release to Zero”...
- Page 7 Note: (i) if the manometer does not start when you press and hold the button for more than 3 seconds, you can try to: open the battery door and check if there are batteries inside; if there are batteries, close the battery door again. At this time, it should automatically start display without any button press.
-
Page 8: Oled Screen Overview
3. OLED Screen Overview The OLED display not only shows pressure readings but also other useful information. For example, the “AVG” screen indicates that the average of 10 seconds is shown in Figure 3.1. The screen display includes: Screen Name: There are “LIVE” screen for 1 second average reading screen, and “AVG”... - Page 9 Unit: the readings are in the unit of Pascal by default. Users can change the unit to inches of water, through the app. Figure 3.1...
-
Page 10: Changing Batteries
4. Changing Batteries The manometer uses two AA batteries. Follow these steps to replace the batteries: 1) Unscrew the battery door screw; 2) Open the battery door; 3) Replace two AA batteries; 4) Close the battery door. Make sure the hinge catches; 5) Drive the battery door screw back in while holding the door closed with your thumb. -
Page 11: Connecting Sampling Tubing
5. Connecting Sampling Tubing The ports are sized to fit 3 mm ID silicone tubing supplied with the instrument. Push and pull the tubing on and off the port, without twisting. 6. The App The manometer can be connected to an Android app, which allows you to see the results remotely and to graph the results over time.
Need help?
Do you have a question about the ES008-M and is the answer not in the manual?
Questions and answers