Table of Contents
Advertisement
Section 1: Assembly & Set-Up
24804
Outer Shielding has been removed for clarity.
Driveline Maximum Extended Length
Figure 1-7
Check Driveline Maximum Length
Refer to Figure 1-7:
The driveline maximum allowable length must, when fully
extended, have a minimum overlap of profile tubes by not
less than 1/2 the free length with both inner and outer
profile tubes being of equal length.
1.
Apply multi-purpose grease to the inside of the outer
shaft and reassemble the driveline.
2. Assemble the two driveline profiles together with just
1/2 overlapping of the profile tubes as shown. Once
assembled, measure and record maximum allowable
length here. ________
3. Reattach driveline to the tractor power take-off shaft
and implement input shaft. Refer to "Driveline
Installation" on page 17 and "Driveline Hook-up"
on page 19.
4. Continue with "Check Driveline Interference"
below.
Check Driveline Interference
Refer to Figure 1-8:
!
WARNING
To avoid serious injury or death:
A rotating driveline must not exceed an angle of 25 degrees up
or down, and never engage a driveline while at an angle
exceeding 25 degrees up or down. The driveline can break and
send projectiles.
1.
Start tractor and raise implement slightly off the
support blocks used to "Check Driveline
Collapsible Length". Drive forward until the
implement is clear of the support blocks.
11/15/19
Table of Contents
24872
Maximum Driveline Movement During Operation
2. Slowly and carefully lower and raise the implement to
ensure drawbar, tires, and other equipment on the
tractor do not contact the implement's frame. If there
is an interference:
a. Back implement over the support blocks and
lower it onto the blocks.
b. Shut tractor down before dismounting. Refer to
"Tractor Shutdown Procedure" on page 17
c. Move or remove drawbar if it interferes with the
implement and make any other necessary
corrections.
d. Repeat steps 1-2 to verify the implement does not
interfere with the tractor.
3. Start tractor, raise implement fully up. Back
implement over the support blocks. Do not lower
implement onto the support blocks.
4. Without changing the 3-point lift height, shut tractor
down using "Tractor Shutdown Procedure".
5. Check to make sure driveline does not exceed any of
the limits listed below:
•
Driveline does not exceed maximum length
recorded in step 2 under "Check Driveline
Maximum Length" on this page.
•
Driveline angle does not exceed 25
horizontal.
6. If driveline exceeds maximum allowable length or 25
degrees up:
a. Adjust tractor 3-point lift limiter to the height that
will keep the driveline within the recommended
limits.
b. If the 3-point left lever does not have a lift height
limiter, make a mark with tape or other means to
indicate maximum lift height.
7.
Start tractor, raise implement slightly, and drive
forward enough to clear the support blocks.
8. Lower implement to ground and shut tractor down
using "Tractor Shutdown Procedure".
Figure 1-8
o
above
WC1503 Wood Chipper 328-085M
21
Advertisement
Table of Contents
