CLS Miriam User Manual

CLS Manuals
CLS Miriam
CLS Manuals
CLS Miriam
Protection from burns and fire
• Do not install the CLS Miriam near a heat source.
• Do not install the CLS Miriam in a corrosive, flammable or explosive area.
• Do not modify the CLS Miriam, or install other than genuine parts.
• Do not operate the CLS Miriam if the ambient temperature exceeds 40º C.
Protection from injury due to falls
• Verify that all covers and mounting hardware is securely fastened.
• Block the access around the work area whenever installing or removing the unit.
ATTENTION!
ThE CLS MIrIAM IS AN IP65 OuTdOOr uNIT, buT uNdEr
NO CIrCuMSTANCES CAN bE uSEd uNdEr wATEr!
CLS Miriam
Version 2.0 March 2010
- 1 - www.cls-led.com
- 3 - www.cls-led.com

INTRODUCTION

Thank you for selecting the CLS Miriam. The CLS Miriam is an universal luminary that uses 37 Luxeon I LEDs
to create an even light-output. The CLS Miriam can be used indoor and outdoor through its waterproof (IP65)
housing. With these qualities the CLS Miriam is mountable almost everywhere.

Available Miriam spots

• CLS Miriam RGB fixture, DMX. 37pcs Luxeon-I, medium frosted
• CLS Miriam RGB fixture, DMX. 37pcs Luxeon-I, narrow clear

Included items

The CLS Miriam is shipped in one package containing the following items:
• 1 x CLS Miriam
• 1 x user manual

Optional accessories

• 140010 CLS Miriam Barndoor
• 140025 CLS Miriam RGB extension cable IP65 5 mtrs
• 140027 CLS Miriam RGB extension cable IP65 10 mtrs
• 140030 CLS Miriam RGB connection cable XLR3-connector 5mtr
• 140040 CLS Miriam RGB DMX cable outdoor
• 140050 CLS Miriam RGB connector set male/female IP65
• 707028 CLS Zense DMX controller + built in 4 amp RGB dimmer
• 707030 CLS ACX60 DMX controller for max. 60 channels
NOTE: It is important to read this manual before you install this product.

SAFETY INFORMATION

Warning! This product is for professional use only, not for domestic use.
Read this manual before powering up or installing the CLS Miriam. Follow the instructions
listed below and observe all warnings in this manual.
Protection from electric shock
• Disconnect the power supply from AC power before installing, dismounting or maintaining the unit.
• Make sure all connectors are connected properly.
• Use only a source of AC power that complies with local building and electrical codes and has both
overload and ground-fault protection.
• Refer all service to a qualified technician.
CLS Manuals
CLS Atmosphere LED-panel

INSTALLATION

This section shows how to install the CLS Miriam.
The CLS Miriam can be installed by using
the mounting hole. Drill a hole to secure it
in the wall, floor, ceiling, etc. Drill a second
hole for the power wire and DMX cables.
CH % FCN OFF
CH % FCN OFF
1 2 3 4 5 6
1 2 3 4 5 6
Connect the DMX cables to the DMX
controller, then put the power wire in the
earthed socket
(item nr. 140000)
(item nr. 140005)
- 2 - www.cls-led.com
o
270
o
270
Adjust the Miriam to the preferred
position by turning the unit towards
or away from the wall.
The CLS Miriam is ready to use.
- 4 - www.cls-led.com