INDEX CLS REVO TRACK DIRECT DMX SERIES Manual PRELIMINARY Index Installation Global adapter Factory settings table Safety information Installation Eutrac adapter Programming table Content Lens replacement Accessories Technical Lens index List of symbols Specifications Programming SAFETY INFORMATION Quali ed Disconnect the...
Page 2
INSTALLATION TECHNICAL With Global adapter Eutrac adapter 110 mm 46 mm 46 mm EUTRAC 84 mm CLS Global 3-phase rail + data 175 mm 186 mm 100 mm Set the adapter 270º to the desired phase by turning the wheel...
INSTALLATION LENS REPLACEMENT With Eutrac adapter CLS Eutrac 3-phase rail Front plate + data Glass Lensholder 90°- 0 - 90° # Y108155 Front plate Glass Lensholder 90°- 0 - 90° Make sure that the items are clean and the rubber...
Page 4
CH5 control master is first channel is selected the channel will be “n+x” master is last channel (“x” is calculated in the output patch). Always use a DMX controller with digital interface. If not available, you can purchase the CLS D-ta DMX addresser unit (#122200). no change Each output channel can be patched to respond DMX channel n to the desired DMX channel. This enables the Output 1 First make sure to set the DATA on the DMX controller. To program the setting into the LED fixture follow the next steps.
Page 5
No part of this manual may be reproduced, against the intrusion of the product in any form or by any means, w ithout permission in writing from CLS-LED BV. Other legal information can be found in our Colour changing...
Need help?
Do you have a question about the REVO TRACK DIRECT DMX SERIES and is the answer not in the manual?
Questions and answers