Web Interface - PowerTec Cellferno M600 Quick Start Manual

Web Interface

Web Interface
Login
LED INDICATORS
1. Launch a web browser.
Login
Login
1. Launch a web browser.
2. In the address bar, enter http://192.168.2.1, then press Enter.
1. Launch a web browser.
2. In the address bar, enter http://192.168.2.1, then press Enter.
2. In the address bar, enter http://192.168.2.1, then press Enter.
3. On the opening screen, enter the username (admin) and password (admin).
3. On the opening screen, enter the username (admin) and password (admin).
3. On the opening screen, enter the username (admin) and password (admin).
4. Step 3: Click OK to login to the main screen.
4. Step 3: Click OK to login to the main screen.
4. Step 3: Click OK to login to the main screen.
5. Click one of the header tabs for Advanced features.
5. Click one of the header tabs for Advanced features.
5. Click one of the header tabs for Advanced features.
The Cellferno CPE uses network domain 192.168.2. x.

For any downstream connections, all devices should avoid using this network
domain otherwise there might be IP address conflict and cause communication
The Cellferno CPE uses network domain 192.168.2. x.
The Cellferno CPE uses network domain 192.168.2. x.

failure.
For any downstream connections, all devices should avoid using this network domain
For any downstream connections, all devices should avoid using this network
otherwise there might be IP address conflict and cause communication failure.
domain otherwise there might be IP address conflict and cause communication
Note
failure.
8
The CPE should connect to the internet without any special settings, if

you require to manually enter an APN follow the steps below.
Note
1. Go to Network > Network Settings > WWAN Setting- APN Profile Table to
enter the APN profile name, then click Add.
The CPE should connect to the internet without any special settings, if

you require to manually enter an APN follow the steps below.
Innovated by