Summary of Contents for PowerTec Cellferno M600
- Page 1 Ignite your mobile broadband Quick Start Guide M600 & M1200 LTE Outdoor CPE Innovated by Innovated by...
-
Page 2: Package Contents
Introduction INTRODUCTION Introduction Introduction Introduction Introduction Introduction Introduction Thank you for purchasing the Cellferno M Series LTE CPE. This high-quality product Thank you for purchasing the Cellferno M Series LTE CPE. This high-quality product is Introduction Thank you for purchasing the Cellferno M Series LTE CPE. This high-quality product is designed to provide high speed internet using the 3G/4G mobile network. -
Page 3: Hardware Overview
HARDWARE OVERVIEW Hardware Overview Hardware Overview 1. Network Port for connecting to the PoE Injector to provide power and data Network Port for connecting to the PoE Injector to provide power and data Network Port for connecting to the PoE Injector to provide power and data 2. -
Page 4: Led Indicators
pole sele LED INDICATORS LED Indicators Next to sim card slot are two LED indicators for power and network signal strength. Next to sim card slot are two LED indicators for power and network signal strength. LED Indicators LED Indicators LED Indicators LED Name Location... - Page 5 Selecting a Location: The LTE Outdoor CPE should be pole-mounted outdoors and aligned so its antenna faces the nearest LTE cell tower. When selecting a suitable location for the CPE, consider these guidelines: • Place as high as possible to achieve the best possible link quality, ideally with Selecting a Location line of sight to the tower.
-
Page 6: Connecting The Cables
Connecting the Cables Connecting the Cables CONNECTING THE CABLES CAT 5 (or Cat5E) Outdoor Shielded Patch Outdoor Connection: Connect a grounding cable between the ground terminal Ethernet cable (not included) on the CPE and a good ground connection. Outdoor Connection Preparing and Connecting the Cable: Connect a grounding cable between the ground terminal on the CPE and a good ground Outdoor Connection: Connect a grounding cable between the ground terminal... - Page 7 Note: Use FTP CAT 5E 4X2X24 AWG outdoor Shielded Patch Cable or above. The total length of the Ethernet cable from the CPE to the PoE must not exceed 80m Indoor Connection With the Ethernet cable now connected to the CPE. Connect the other end of the cable to the PoE adaptor port labeled “PWR+DATA OUT”.
-
Page 8: Web Interface
Web Interface Web Interface Login LED INDICATORS Launch a web browser. Login Login Launch a web browser. In the address bar, enter http://192.168.2.1, then press Enter. 1. Launch a web browser. In the address bar, enter http://192.168.2.1, then press Enter. 2. - Page 9 Note The CPE should connect to the internet without any special settings, if you require to manually enter an APN follow the steps below. 1. Go to Network > Network Settings > WWAN Setting-APN Profile Table to enter the APN profile name, then click Add. 2.
- Page 10 Innovated by...
- Page 11 Innovated by...
- Page 12 Cellferno is distributed and a Trademark of: Powertec Telecommunications Pty Ltd 16/511 Olsen Avenue Southport Qld 4214 Australia Ph: +61 7 5577 0500 Email: sales@powertec.com.au Innovated by...
Need help?
Do you have a question about the Cellferno M600 and is the answer not in the manual?
Questions and answers