Connecting The Cables - PowerTec Cellferno M600 Quick Start Manual

Connecting the Cables

Connecting the Cables
CONNECTING THE CABLES
Outdoor Connection: Connect a grounding cable between the ground terminal
on the CPE and a good ground connection.
Outdoor Connection
Preparing and Connecting the Cable:
Connect a grounding cable between the ground terminal on the CPE and a good ground
Outdoor Connection: Connect a grounding cable between the ground terminal
1. Connect the Cable
connection.
on the CPE and a good ground connection.
• Remove the sealing cable gland plug from the CPE.
Preparing and Connecting the Cable
Open the sealing gland nut and remove it. Disassemble the rubber
Preparing and Connecting the Cable:
1. Connect the Cable
bushing.
1. Connect the Cable
• Remove the sealing cable gland plug from the CPE. Open the sealing gland nut and
• Insert the cable into the sealing gland base and connect it to the Ethernet
remove it. Disassemble the rubber bushing.
• Remove the sealing cable gland plug from the CPE.
port at the base of the CPE. Make sure the connector is completely inserted
Open the sealing gland nut and remove it. Disassemble the rubber
• Insert the cable into the sealing gland base and connect it to the Ethernet port at the
and tightened.
bushing.
base of the CPE. Make sure the connector is completely inserted and tightened.
• Insert the rubber bushing on the cable and then into the gland base.
• Insert the rubber bushing on the cable and then into the gland base.
• Insert the cable into the sealing gland base and connect it to the Ethernet
port at the base of the CPE. Make sure the connector is completely inserted
and tightened.
• Insert the rubber bushing on the cable and then into the gland base.
• Tighten the sealing gland nut.
Note
Use FTP CAT 5E 4X2X24 AWG outdoor Shielded Patch Cable or above. The total length of the
Ethernet cable from the CPE to the PoE must not exceed 80m
6
CAT 5 (or Cat5E) Outdoor Shielded Patch
Ethernet cable (not included)
Innovated by
6
6