Advertisement
2. Place the levers (with the mounting plates toward the
rear of the machine) on the outside of the control arm
shaft and loosely secure them with the 4 bolts and
curved washers removed in step 1 (Fig. 3).
1
2
3
Figure 3
1. Control arm
2. Bolt, 3/8 x 1 inch
3. Position the levers so that the bolts are in the center of
the slots on the lever mounting plate and tighten the
bolts until they are snug.
4. Align the front/rear position of the levers with each
other while in the neutral position. Loosen the bolts and
adjust the levers by sliding and/or tilting the lever(s)
forward or backward until they are properly aligned.
5. If the ends of the motion control levers hit against each
other while they are in the drive position (Fig. 4) (the
levers are rotated in as far as possible), make
adjustments by moving the levers outward to the neutral
lock position and carefully bend them outward. Move
them back to the drive position and check for clearance.
Repeat if necessary.
FRONT
OF
UNIT
LEVERS IN
ALIGNMENT
Figure 4
Installing the Seat
1. Cut the plastic ties securing the seat to the machine for
shipping. Remove the seat.
4
m–5215
3. Curved washer, 3/8 inch
4. Control arm shaft
2. Remove the knobs and flat washers (5/16 inch) from the
seat support.
3. Remove the spacers between the seat and seat support.
4. Raise the seat support on the machine (Fig. 5).
5. Slide the shoulder bolts on the bottom of the seat into
the slots on the seat support (Fig. 5).
6. Secure the seat to the seat support with the spacers, flat
washers and knobs removed in step 2 and 3 (Fig. 5).
2
3
1
Figure 5
1. Seat support
2. Shoulder bolt
Important
Make sure the spacers are between the seat
and support, and the knobs pass through the washers, seat
support, spacers and into the seat (Fig. 6).
1
5
4
3
Figure 6
1. Seat
2. Seat support
3. Knob
7. Lower the seat and adjust it if necessary; refer to
Positioning the Seat in the Operator's Manual.
3
m–5579
3. Knob
2
m–7546
4. Washer
5. Spacer
Advertisement
