Technical Data - Bosch 200 R Installation Manual

Installation information for cylinder without solar coil
396
=
100
Fig. 69 Ceiling connection dimensions 200
=
100
Fig. 70 Ceiling connection dimensions 300
Filling the water heater
WARNING: The water heater can crack if filling is
performed in the wrong order.
▶ Fill and pressurise the water heater before filling the
heating system.
Do not forget to vent after filling the outer shell and
commissioning the system.
Anode
For extra safety there is an electronic sacrificial anode installed in the
water heater (model R). The task of the anode is to protect against
32
=
100
6720646738-07.1I
471
=
100
6720646738-08.1I
corrosion to give the water heater a longer service-life. In cases where
there are thought to be high amounts of chlorides in the water (>10 mg/
litre), inspect the anode every 1-2 years. The anode (aluminium) which
is on the top of the water heater has an original diameter of 20 mm. If it
has been affected, e.g. its diameter has been reduced to 5-8 mm or is 10
cm long, it should be replaced and re-inspected after 2-3 years.
▶ Pressurise the water heater (outer-shell first).
▶ Shut off the main cold water supply.
▶ Open the venting cock.
▶ Unscrew the anode at the top of the water heater, check and replace
if necessary.
In confined spaces (low ceiling heights) a chain anode is available as an
alternative. Order anodes from your local installer specifying the tank
model.

Technical data

Model Unit
Volume of hot water litres
Outer shell volume litres
Hot/cold connection Cu
Outer shell inches
connection
Submerged tube mm
sensor
Immersion heater inches
connection
Working pressure bar
radiator
Working pressure bar
hot water
Aluminium anode
Dimensions mm
(WxDxH)
Weight kg
Table 2 Technical data
200-300 R/C, 200-300 R, 360 C – 6 720 801 192 (2017/07)
200 R 300 R 200 C
185 286 185
105 176 105
22 28 22
G25
9,5
- 2 -
3 2,5 3
10
Yes Yes -
600x600 695x695 600x600
x1520 x1700 x1520
97 136 108
300 C
286
176
28
2
2,5
-
695x695
x1700
151