13. Replace:
•Hex-head screws in side panel and the Phillips screws in rear splash guard
•Motor spill guard
•Maintop
•Vent trim
•RJ45 connector to square hole of rear wire cover
•Backguard complement strip and rear wire cover
•Rear spacer-to-wall trim
•Top burners and grates.
14. Power unit and check for cooling blower operation one more time per Step 2. Start a
self-clean cycle and listen for rattles with fan operating at high speed, then cancel self-
clean operation.
If holes aren't aligning easily,
consider leaving out the two screws
indicated. Driving these screws
under tension may deform ducting
and cause blower to bind.
4