Tri-Pack 50 Series
Non Handed Door Closer
Regular Arm
Installation
See Page 2
Right Hand Door - RH
Left Hand Reverse - LHR
Top Jamb
Installation
See Page 5
Left Hand Door - LH
Right Hand Reverse - RHR
Parallel Arm
Installation
See Pages
Left Hand Door - LH
Right Hand Reverse - RHR
Spring Power Adjustment Screw
51(BF) Series Only
"BC" Valve
4
Closer
Size
Stamp
Pinion Cap
Installation Instructions
80-9350-2502-010 (05-12)
An Incorrectly installed or improperly adjusted
door closer can cause property damage or
personal injury. These installation instructions
should be followed to avoid the possibility of
misapplication or misadjustment.
"DL" suffix (Delayed Action) is an optional
feature. A separate sheet is supplied
showing closer adjustments.
NOTE: For special applications a separate
door and frame preparation template is
packed with these instructions. Use this
instruction sheet for installation sequence
and closer adjustments only.
Doors should be hung on ball bearing or
anti-friction hinges.
A separate door stop is recommended.
Door and frame must be properly
reinforced.
Adjust closing time speed between 3 and 7
seconds from 90° to 0°.
These door closers should NOT be
installed on the exposed side (weather
side) of exterior doors.
3 & 4
#7
Metal
Standard Components
Closer Body
"L"Valve
"S"Valve
3/16" Pilot hole
required
1/4-20
Wood
Regular Arm/Top
Jamb Shoe
Connecting Rod
Soffit Plate
289A Soffit Plate
Used with Parallel
Arm Closers Only
Non Hold Open Models
Sized
(Sizes 2,3,4,5,6)
Weaker
52BC
-
53BC
54BC
55BC
Stronger
56BC
+
Regular Arm
Installation
See Page 2
Left Hand Door - LH
Right Hand Reverse - RHR
Top Jamb
Installation
See Page 5
Right Hand Door - RH
Left Hand Reverse - LHR
Parallel Arm
Installation
See Pages
3 & 4
Self Drilling Screws
Wood and Metal
For Wood drill 3/16 hole
Machine Screws
#7 Drill, 1/4-20 Tap
Arm Assembly
Optional Components
Main Arm
Forearm
Arm Slide
Screw
Adjustable
(Sizes 3 thru 6)
51
(Sizes 1 thru 4)
51BF
Right Hand Door - RH
Left Hand Reverse - LHR
(Optional)
Sleeve Nut and Bolt
Drill 9/32 thru from Closer Side
3/8 Drill other side
Thru Bolt and Grommet Nut
Drill
9/32 thru from Closer Side
3/8 Drill other Side
C o
v e
r